Hyundai Accent: Interior Trim / Door Scuff Trim
1. Front door scuff trim
2. Rear door scuff trim
[Front door scuff trim]
• Put on gloves to prevent hand injuries.
• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
• Take care not to bend or scratch the trim and panels.
1.Carefully remove the front door body side weatherstrip.
2.Using a screwdriver or remover, remove the front door scuff trim (A).
3.To install, reverse the removal procedure.
• Replace any damaged clips (or pin - type retainers).
[Rear door scuff trim]
• Put on gloves to prevent hand injuries.
• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
• Take care not to bend or scratch the trim and panels.
1.Carefully remove the rear door body side weatherstrip.
2.Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")
3.Loosen the mounting screws and remove the rear door scuff trim (A).
4.To install, reverse the removal procedure.
• Replace any damaged clips (or pin - type retainers).
Other information:
Hyundai Accent (HC) (2017 - 2022) Service Manual: Variable Force Solenoid (VFS)
- Description CVVT (Continuous Variable Valve Timing) system advances or retards the valve opening and closing timing of the intake or the exhaust valve in accordance with the ECM control, calculated by the engine speed and the load. The CVVT control causes a valve over-lap or under-lap between the intake valve and the exhaust valve. This improves fuel efficiency, reduces exhaust gases (NOx, HC) and enhances the engine performance, thanks to reduced pumping loss, internal EGR (Exhaust Gas Recirculation) release, improved combustion stability, and increased volumetric efficiency.Hyundai Accent (HC) (2017 - 2022) Service Manual: Specifications
- Specifications ItemSpecification Master cylinderTypeSingle Cylinder I.D.20.64 mm Piston stroke36 ± 1 mm (1.41 ± 0.039 in) Fluid level switchProvided Brake boosterType10" Single Boosting ratio8.0 : 1 Front disc brakeTypeVentilated disc Disc O.D.Ø 280 mm (11.02 in) Disc thickness22 mm (0.87 in) Caliper pistonSingle Cylinder I.D.Ø 54.
Categories
- Manuals Home
- Hyundai Accent Owners Manual
- Hyundai Accent Service Manual
- New on site
- Most important about car
