Hyundai Accent: Body Electrical System / Fuses And Relays

Components and Components Location

- Component Location

[Passenger Compart Relay]

Junction Box (Engine Compartment)

- Component Location E/R Junction Block

1.Disconnect the negative (-) battery terminal.

2.Pull out the relay from the engine compartment relay block.

3.Check for continuity between the terminals.

1)After supplying power to between No. 85 and 86 power relay terminals, check that there is continuity between No. 30 and 87 terminals.

2)After disconnecting power between No. 85 and 86 power relay terminals, check that there is no continuity between No. 30 and 87 terminals.

1.Be sure there is no play in the fuse holders, and that the fuses are held securely.

2.Are the fuse capacities for each circuit correct?

3.Are there any blown fuses?If a fuse is to be replaced, be sure to use a new fuse of the same capacity. Always determine why the fuse blew first and completely eliminate the problem before installing a new fuse.

– Multi fuse is needed to replace in the mass when it damaged only one fuse.

– When replace the multi fuse, refer to the "Engine compartment - component location" diagram exactly.

– Use the multi fuse capacities for each circuit correctly.

Junction Box (Passenger Compartment)

- Component Location I/P Junction Block

1.Be sure there is no play in the fuse holders, and that the fuses are held securely.

2.Are the fuse capacities for each circuit correct?

3.Are there any blown fuses?If a fuse is to be replaced, be sure to use a new fuse of the same capacity. Always determine why the fuse blew first and completely eliminate the problem before installing a new fuse.

1.The Interior Junction Block can be diagnosed by using the GDS. The Interior Junction Block communicates with the GDS which then displays inputs and outputs along with codes.

2.To diagnose the Interior Junction Block function, select the vehicle model, Interior.

3.To consult the present input/out value of Interior Junction Block, "Current DATA". It provides information of Interior Junction Block input/output conditions.

4.To perform functional test on Interior Junction Block outputs, select "Actuation Test"

1.Disconnect the negative(-) battery terminal.

2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")

3.Disconnect the connectors (A) from the fuse side of the junction block.

4.Remove the junction block (A) after loosening the mounting nuts.

5.Disconnect the connectors (A) from the back side of the junction block.

1.Install the Interior junction block.

2.Install the crash pad lower panel.

3.Check that all system operates normally.