Hyundai Accent: Body (Interior and Exterior) / Hood
Repair procedures
1.After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt.
2.Adjust the hood height by moving the hood overslam bumpers (C) up and down.
3.After loosening the hood latch (D) mounting bolts, adjust the latch by moving it up and down or from side to side.
Hood Assembly
1. Hood assembly
• Be careful not to damage the hood and body.
• Removing or installing the hood requires an assistant.
• When removing the clips, use a clip remover.
1.After loosening the hood hinge (A) mounting bolts, remove the hood assembly (B).
Tightening torque : 21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)
2.To install, reverse the removal procedure.
• Make sure the hood locks / unlocks and opens / closes properly.
• Adjust the hood alignment.
Hood Weatherstrip
1.Remove the hood weatherstrip (A).
• Be careful not to scratch the hood weatherstrip.
2.To install, reverse the removal procedure.
Hood Latch Release Handle
1. Hood latch release handle
1.Pull out the hood latch release handle.
2.Disconnect the hood latch release handle cable (A).
3.After loosening the mounting screws, then remove the hood latch release handle (A).
4.To install, reverse the removal procedure.
• Make sure the hood latch cable is connected properly.
• Make sure the hood locks / unlocks and opens / closes properly.
Hood Latch
1. Hood latch assembly
1.Disconnect the hood lower latch connector (A).
2.Disconnect the hood latch wiring (A).
3.Loosen the mounting bolts and remove the hood lower latch assembly (A).
4.Disconnect the hood latch cable (A) and remove the hood latch (B).
5.To install, reverse removal procedure.
• Make sure the hood latch release cable is connected properly.
• Make sure the hood locks/unlocks and opens/closes properly.
• Adjust the latch alignment.
• Replace any damaged clips (or retainers or fasteners)
Other information:
Hyundai Accent (HC) (2017 - 2022) Service Manual: Variable Force Solenoid (VFS)
- Description CVVT (Continuous Variable Valve Timing) system advances or retards the valve opening and closing timing of the intake or the exhaust valve in accordance with the ECM control, calculated by the engine speed and the load. The CVVT control causes a valve over-lap or under-lap between the intake valve and the exhaust valve. This improves fuel efficiency, reduces exhaust gases (NOx, HC) and enhances the engine performance, thanks to reduced pumping loss, internal EGR (Exhaust Gas Recirculation) release, improved combustion stability, and increased volumetric efficiency.Hyundai Accent (HC) (2017 - 2022) Service Manual: Troubleshooting
- Troubleshooting SymptomSuspect areaRemedy Engine misfire with abnormal internal lower engine noises.Loose or improperly installed drive plate.Repair or replace the drive plate as required. Worn piston rings.(Oil consumption may or may not cause the engine to misfire.)Inspect the cylinder for a loss of compression .Repair or replace as required.
Contents
Categories
- Manuals Home
- Hyundai Accent Owners Manual
- Hyundai Accent Service Manual
- New on site
- Most important about car
