Hyundai Accent: Body Electrical System / Power Door Mirrors
Components and Components Location
1. Power door mirror
2. Power door mirror switch
3. Power door mirror contral (LH/RH)
Power Door Mirror Switch
1.Disconnect the negative (-) battery terminal.
2.Remove the front left door trim.(Refer to Body - "Front Door Trim")
3.Remove the door mirror switch assembly (A) by pulling out both ends of the switch holders (B).
1.Install the power mirror switch.
2.Install the front door trim after connecting the connector.
3.Connect the negative (-) battery terminal.
1.Remove the front left door trim.(Refer to Body - "Front Door Trim")
2.Remove the power mirror switch (A) from the door trim.
3.Check for continuity between the terminals in each switch position according to the table.
Power Door Mirror Actuator ➤
Other information:
Hyundai Accent (HC) (2017 - 2022) Service Manual: Sub Frame
- Removal 1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported. 2.Remove the front wheel and tire (A) from the front hub.Tightening torque :107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft) • Be careful not to damage the hub bolts when removing the front wheel and tire. 3.Hyundai Accent (HC) (2017 - 2022) Service Manual: A/C Pressure Transducer
- Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed. Engine ECU stops the operation of the compressor when the temperature of refrigerant line is very high or very low irregularly to optimize air conditioning system.
Contents
Categories
- Manuals Home
- Hyundai Accent Owners Manual
- Hyundai Accent Service Manual
- New on site
- Most important about car
