Hyundai Accent: Advanced Driver Assistance System (ADAS) / Rear View Monitor (RVM)
Components and Components Location
- Component Location

1. Rear view camera
2. AVN monitor
Schematic Diagrams
- Circuit Diagram

Description and Operation
- Description
Rear view camera will activate when the backup light is ON with the
ignition switch ON and the shift lever in the R position.This system is a
supplemental system that shows behind the vehicle through the AV
monitor or the ECM (Reverse Display Room Mirror) mirror while
backing-up.
This system is a supplementary function only. It is the responsibility
of the driver or always check the inside/ outside rear view mirror and
the area behind the vehicle before and while backing up because there is
a dead zone that can't see through the camera.
Repair procedures
- Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the trunk trim.(Refer to Body - "Trunk Rid Trim")
3.Remove the trunk back panel.(Refer to Body - "Trunk back Panel")
4.Remove the rear center tail lamp.(Refer to Lighting System - "Rear Combination Lamp")
5.Loosen the mounting screw and then remove the camera (A).

6.Remove the rear camera after turning in the counterclockwise direction.

- Installation
1.Install the rear view camera.
2.Install the and trunk back panel.
3.Install the and trunk rid trim.
4.Connect the negative (-) battery terminal.