Hyundai Accent: Multifunction Switch / Repair procedures

Hyundai Accent (HC) (2017 - 2022) Service Manual / Body Electrical System / Multifunction Switch / Repair procedures

- Removal

1.Disconnect the negative (-) battery terminal.

2.Remove the steering wheel.(Refer to Steering System - "Steering Wheel")

3.Remove the steering column upper and lower shrouds after loosening the screws.(Refer to Body - "Steering Column Shroud Panal")

4.Remove the clock spring.(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")

5.Remove the multifunction switch assembly (A) after loosening the screws and disconnecting the connector (B).

- Installation

1.Install the multifunction switch.

2.Install the clock spring.

3.Install the steering column upper and lower shrouds.

4.Install the steering wheel.

- Inspection Multifunction Switch Inspection

1.Check for continuity between the terminals in each switch position according to the table.

Switch	Switch position	Switch terminal	Resistance (Ω, ±3.5%)
Front wiper switch	MIST	1-11	330
	OFF		∞
	Intermittent (AUTO)		800
	LOW		1800
	HIGH		5700
Wiper intermittent volume	Volume 1	7-11	330
	Volume 2		690
	Volume 3		1310
	Volume 4		2610
	Volume 5		7310
Rear wiper switch	OFF	11-16	∞
	LOW		910
	HIGH		2910
Fog lamp switch	OFF	11-10	∞
	Front foglamp		910
	Rear foglamp		2000
Turnsignal switch	OFF	11-12	∞
	Left		910
	Right		2910
Dimmer & Passing switch	OFF	11-13	∞
	Passing		910
	Dimmer		2910
Light switgh	OFF	11-14	680
	AUTO / DRL		∞
	Tail lamp		1680
	Low beam		5580

Inspection (With Diagnostic tool)

1.In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool).The diagnostic system (Diagnostic tool) provides the following information.

(1)Fault Code Searching : Checking failure and code number (DTC)

(2)Data Analysis : Checking the system input/output data state

(3)Actuation test : Checking the system operation condition

(4)S/W Management : Controlling other features including system option setting and zero point adjustment

2.If diagnose the vehicle by Diagnostic tool, select "DTC Analysis" and "Vehicle".

3.If check current status, select the "Data Analysis" and "Car model".

4.Select the 'IBU_BCM' to search the current state of the input/output data.

Other information:

Hyundai Accent (HC) (2017 - 2022) Service Manual: Manual Transaxle Fluid

- General Information 1.Check & Change intervals Check & ReplenishmentChangeCapacityOil specification Normal useSevere Use 60,000 km / 4 years(40,000 miles / 4years) No service required120,000 km(80,000 miles)1.5 - 1.6 L(0.40 -0.42 U.S.gal., 1.58 - 1.69 U.S.qt., 1.32- 1.40 lmp qt.)API Service GL-4, SAE 70W • Recommended oil – SHELL : SPIRAX S6 GHME 70W MTF – SK : HK SYN MTF 70W – GS CALTEX : GS MTF HD 70W Severe usage is defined as • Driving in dusty, rough roads • Driving in areas using salt or other corrosive materials or in very cold weather • Driving in sandy areas • Driving in mountainous areas • Towing a trailer • Driving for patrol car, taxi, commercial car or vehicle towing • Driving over 170 Km - Inspection 1.

Hyundai Accent (HC) (2017 - 2022) Service Manual: Troubleshooting

- Troubleshooting SymptomSuspect areaRemedy Engine misfire with abnormal internal lower engine noises.Loose or improperly installed drive plate.Repair or replace the drive plate as required. Worn piston rings.(Oil consumption may or may not cause the engine to misfire.)Inspect the cylinder for a loss of compression .Repair or replace as required.

Hyundai Accent: Multifunction Switch / Repair procedures

Multifunction Switch

Audio

Other information:

Categories