Hyundai Accent: Body Electrical System / Windshield Wiper/Washer

Components and Components Location

- Component Location

1. Windshield wiper arm & blade
2. Wiper & washer switch
3. Windshield washer hose
4. Windshield wiper motor & linkage
5. Washer motor
6. Washer reservoir
7. Front wiper relay

Windshield Wiper-Washer Switch ➤

Front Wiper Motor ➤

Front Washer Motor

- Inspection Front and Rear Washer Motor

1.With the washer motor connected to the reservoir tank, fill the reservoir tank with water.

2.Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.

3.If they are abnormal, replace the washer motor.

1.Disconnect the negative (-) battery terminal.

2.Drain the washer fluid less than 700 cc.

3.Check for continuity between the No. 1 and No.2 terminal in each float position.There should be continuity when the float is down.There should be no continuity when the float is up.If the continuity is not as specified, replace the washer fluid level switch.

– When servicing the washer pump, be careful not to damage the washer pump seal.

– Do not operate the washer pump before filling the washer reservoir.Failure to do so could result in premature pump failure.

1.Disconnect the negative (-) battery terminal.

2.Remove the front right wheel guard.(Refer to Body - "Front Wheel Guard")

3.Disconnect the washer motor connector (A) and washer hose (B) and washer level sensor connector (C).

4.Remove the washer reservoir (A) after loosening the mounting bolts (B).

5.Remove the washer motor (A) from the washer reservoir.

6.Remove the washer level sensor switch (A).

1.Reassemble the washer reservoir.

2.Connect the washer motor connector and washer hose.

3.Reassemble the front bumper cover.