Hyundai Accent: Interior Trim / Front Pillar Trim

Hyundai Accent (HC) (2017 - 2022) Service Manual / Body (Interior and Exterior) / Interior Trim / Front Pillar Trim

- Component Location

1. Front pillar trim


- Replacement

   

• Put on gloves to prevent hand injuries.

   

• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

• When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

• Take care not to bend or scratch the trim and panels.

1.Remove the front pillar trim.

(1)To remove the front pillar trim, the fastener remover (A) below must be used.

(2)After slightly lifting up the front pillar trim and putting the tool in, remove the mounting clip (A) by pulling it.

   

• Be sure to replace the existing clips with new ones when removing or replacing the front pillar trim.

(3)Remove the front pillar trim (A).

2.To install, reverse the removal procedure.

   

• Replace any damaged clips (or pin - type retainers).

• Be sure to replace the existing clips with new ones when removing or replacing the front pillar trim.

Interior Trim

Trunk Trim

Other information:

Hyundai Accent (HC) (2017 - 2022) Service Manual: Floor Console Assembly

- Replacement [Manual consle]     • Put on gloves to prevent hand injuries.     • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Hyundai Accent (HC) (2017 - 2022) Service Manual: Repair procedures

- Diagnosis with Diagnostic tool 1.In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool).The diagnostic system (Diagnostic tool) provides the following information.(1)Fault Code Searching : Checking failure and code number (DTC) (2)Data Analysis : Checking the system input/output data state (3)Actuation test : Checking the system operation condition (4)S/W Management : Controlling other features including system option setting and zero point adjustment Data Analysis 1.

Categories

 
Copyright © 2025 hc.hamanual.com