Hyundai Accent: Body (Interior and Exterior) / Rear Seat

Components and Components Location

- Components

1. Rear seat cushion pad
2. Rear seat cushion covering
3. Rear seat back covering
4. Rear seat back pad
5. Rear seat back board
6. Rear seat back frame
7. Rear seat back bezel
8. Rear seat headrest guide
9. Rear seat headrest

Rear Seat Assembly

- Component Location

1. Rear seat cushion assembly
2. Rear seat back assembly

1.Remove the rear seat cushion assembly (A) after loosening the bolt.

Tightening torque : 21.6 - 31.4 N·m (2.2 - 3.2 kgf·m, 15.9 - 23.1 lb·ft)

2.Disconnect the rear center seat belt (A).

3.Open the rear seat center hinge (A) after loosening the mounting bolt.

Tightening torque : 21.6 - 31.4 N·m (2.2 - 3.2 kgf·m, 15.9 - 23.1 lb·ft)

4.Remove the rear seat back assembly (A).

5.Install in the reverse order of removal.

Rear Seat Back Cover ➤

Rear Seat Cushion Cover

- Component Location

1. Rear seat cushion cover

• Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

• Take care not to bend or scratch the trim and panels.

1.Remove the seat assembly.(Refer to Rear Seat - "Rear Seat Assembly")

2.Remove the rear seat cushion cover (A) after removing the hog-ring clips on the rear of seat cushion cover.

3.Install in the reverse order of removal.

• Make sure that the connectors are plugged in properly.

• Replace any damaged clips.

• To prevent wrinkles, make sure that the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).

• Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).