Hyundai Accent: Motor Driven Power Steering / Repair procedures

- A/S Repair produres MDPS System A/S Workflow

1.Checking Connectors and Wiring.Check for damage, push-back, or improper connection in each connector and wiring.

(1)Check the wiring on the vehicle side.

– Check for open / short - circuit due to faulty connection, damage, or foreign substance.

(2)Check the wiring on the ECU side (motor 3 - phase power).

– Check for open / short - circuit due to faulty connection, damage, or foreign substance.

(3)Check the motor connector.

– Terminal Expansion and damage

• Must be replaced the MDPS motor if occur terminal expansion and damage.

(4)Check the motor wiring.

• Must be replaced the MDPS motor if occur damage or problem.

(5)Remove the grommet (A) and then check the wiring on the TAS side (B) and ECU side (C).

– Check for damage, push-back, or improper connection in each connector and wiring.

1.Inspect steering angle and DTCs relevant to the steering system.

2.Inspection for heavy steering effort

(1)Inspect tire pressure and width.

(2)Check DTCs relevant to the CAN communication error.

(3)Check the wheel alignment.

• Failure occurs due to internal damage because of the drop of and shock and excessive external force on the new partial component.→ Be cautious of shock on the partial component and replace the damaged part (due to drop, etc.) with a new one.

• When fastening the steering, excessive impact may result in twisting the center point of the torque sensor.

• When removing/installing the connector the wiring may be damaged (deformed) by excessive external force.

• Be cautious when storing and replacing the partial components under the abnormal temperature and humidity conditions.