Hyundai Accent: Manual Transaxle Control System / Control Cable

- Components

1. Shift lever knob & boots
2. Shift lever assembly
3. Select cable
4. Shift cable
5. Retainer
6. 4th fixing pin

1.Move the shift lever to 4th gear.

2.Turn OFF ignition switch and disconnect the negative (-) battery cable.

3.Remove the air cleaner assembly and air duct.(Refer to Engine Mechanical System - "Air Cleaner")

4.Remove the battery and battery tray.(Refer to Engine Electrical System - "Battery")

5.Remove the Engine Control Module (ECM).(Refer to Engine Control System - "ECM")

6.Separate the control cable.

1)Remove the snap pin (A).

2)Separate the select cable (B) and then shift cable (C).

7.Remove the shift knob & boot (A).

8.Remove the floor console assembly. (Refer to Body - "Floor Console")

9.Separate the select cable (B), after removing the snap pin (A).

10.Remove the shift cable.

(1)Remove the cable socket (A), after release the lock.

(2)Remove the clip, in the shape of a "U"(B), from the cable end by spreading it towards both sides.

11.Loosen the nuts and then removing the retainer (A).

12.Remove the control cable assembly (A) from the vehicle.

• Place the shift lever and transaxle side lever in 4th shift position and insert the lever fixing pin (A).

1.Install the retainer (A) and then tighten the nuts (B).

Tightening torque :11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb-ft)

2. Install the select cable (B), and then fixing the snap pin (A).

3.Install the shift cable (A).

• After installing the select cable and shift cable socket, check portion (A) to see if it projects outwards from the cap.

4.Move the locker (B) in the direction of "F" with pulling the holder (A) in the direction of "P".

5. Install the control cable.

1)Install the snap pin (A).

2) Separate the select cable (B) and then shift cable (C).

6.Tighten the holder (A) to the "P" directions after fixing the rockers (B) in the "F" direction.

7.Remove the shift lever 4th fixed pin (A).

8.Install the floor console assembly.(Refer to Body - "Floor Console")

9.Install the battery and battery tray.(Refer to Engine Electrical System - "Battery")

10.Install the engine control module (ECM).(Refer to Engine Control System - "ECM")

11. Install the air cleaner assembly and air duct.(Refer to Engine Mechanical System - "Air Cleaner")

• Check operating of lever of transaxle side when operating shift lever after assembly. (1~6,R)

• If there is sticky feel, adjust the control cable length again.(Refer to Control Cable - "Installation")