Hyundai Accent: Manual Transaxle System (M6CF1) / Manual Transaxle Control System

Shift Lever

- Components

1. Shift lever knob & boots
2. Shift lever assembly
3. Select cable
4. Shift cable
5. Retainer
6. 4th fixing pin

1.Turn OFF ignition switch and disconnect the negative (-) battery cable.

2. Remove the shift lever knob & boots (A) pull both of it up.

3.Remove the floor console assembly. (Refer to Body - "Floor Console")

4.Separate the select cable (B), after removing the snap pin (A).

5. Remove the shift cable.

(1)Remove the cable socket (A), after release the lock.

(2)Remove the clip, in the shape of a "U"(B), from the cable end by spreading it towards both sides.

6.Loosen the bolts and then removing the shift lever (A).

Tightening torque :8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)

1.To install, reverse the removal procedures.

• New shift lever assembly is mounted in the 4th fixing pin.After installation, remove the 4th fixed pin.

• After installing the select cable and shift cable socket, check portion (A) to see if it projects outwards from the cap.

• Check operating of lever of transaxle side when operating shift lever after assembly. (1~6,R)

• If there is sticky feel, adjust the control cable length again.(Refer to Control Cable - "Installation")

Control Cable ➤

Control Shaft Complete ➤