Hyundai Accent: Roof Trim / Roof Trim Assembly

- Component Location

1. Roof Trim Assembly

• Put on gloves to prevent hand injuries.

• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

• When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

• Take care not to bend or scratch the trim and panels.

1.Remove the door weatherstrip.

2.Remove the front seat. (Refer to Front Seat - "Front Seat Assembly")

3.Remove the rear seat. (Refer to Rear Seat - "Rear Seat Assembly")

4.Remove the front pillar trim.(Rear to Interior Trim - "Front Pillar Trim")

5.Remove the center pillar lower trim.(Rear to Interior Trim - "Center Pillar Trim")

6.Remove the center pillar upper trim.(Rear to Interior Trim - "Center Pillar Trim")

7.Remove the rear pillar trim.(Rear to Interior Trim - "Rear Pillar Trim")

8.Remove the sunvisor and retainer.(Rear to Roof Trim - "Sunvisor")

9.Remove the assist handle.(Rear to Roof Trim - "Assist Handle")

10.Remove the overhead console lamp.(Rear to Body Electrical System - "Overhead Console Lamp")

11.Remove the room lamp.(Rear to Body Electrical System - "Room Lamp")

12.Remove the rear window glass.(Refer to Body(Interior and Exterior) - "Rear Window Glass")

13.Remove the roof trim mounting clip and remove the roof trim assembly (A).

• Be careful not to wrinkle on the roof trim.

14.Disconnect the roof connector (A).

15.Remove roof trim wiring harness (A) from the roof trim (B).

16.To install, reverse the removal procedure.

• Make sure the connector is connected in properly.

• Replace any damaged clips.