Hyundai Accent: Body (Interior and Exterior) / Troubleshooting
Hyundai Accent (HC) (2017 - 2022) Service Manual / Body (Interior and Exterior) / Troubleshooting
| Symptom | Passible Cause | Remedy (Refer to page) |
| Water leaks from panorama sunroof | Deteriorated roof lid weatherstrip | Replace |
| Excessive roof lid - to - body clearance and improperly fitted weatherstrip | Adjust | |
| Wind noise around sunroof | Loose or deformed deflector, gaps in body work | Retighten adjust or replace |
| Noise created by moving sunroof lid | Foreign particles lodged in guide rail | Check drive cable and guide rails for foreign particles |
| Loose guide rails and lid | Retighten | |
| Motor runs but sunroof does not move or moves only partially | Foreign particles lodged in guide rail | Adjust or replace |
| Incorrect engagement of motor pinion with drive cable | ||
| Decrease in motor's clutch slipping force | ||
| Increased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc. due tomal adjustment of sunroof | ||
| Noise in motor (clutch slipping noise from motor when sunroof is fully opened or closed) is considered as normal | Incorrect engagement of motor pinion with drive cable | Check pinion installation and |
| Re - tighten motor | ||
| Worn out or damaged motor pinion bearing | Replace motor assembly | |
| Worn out or deformed drive cable | Replace | |
| Door glass fails to operate up and down | Incorrect window glass installation | Adjust position |
| Damaged or faulty regulator arm or regulator | Correct or replace | |
| Door does not open or close completely | Incorrect door installation | Adjust position |
| Defective door check assembly | Correct or replace | |
| Door hinge requires grease | Apply grease | |
| Hood does not open or close completely | Striker and latch not properly aligned | Adjust |
| Incorrectly installed hood | Adjust | |
| Incorrect hood bumper height | Adjust | |
| Water leaks through windshield and rear window | Defective seal | Fill with sealant |
| Defective flange | Correct |
Other information:
Hyundai Accent (HC) (2017 - 2022) Service Manual: Alternator
- Specification ItemSpecification Rated voltage13.5V, 130A Speed in use 1,000 - 18,000 rpm Voltage regulatorIC Regulator built-in type Regulator Setting VoltageExternal mode 10.6 - 16 ± 0.3V Internal mode14.5 ± 0.3V Temperature GradientExternal mode0 ± 2 mV / °C Internal mode-3.5 ± 2 mV / °C - Description The Alternator has eight built-in diodes, each rectifying AC current to DC current.Hyundai Accent (HC) (2017 - 2022) Service Manual: Ignition Lock Switch
- Specifications ItemSpecifications Working voltageDC 12.5V ± 0.3V Operating forceInitial position : 0.25 ± 0.15N(0.025 ± 0.015kg, 0.056 ± 0.034lb) Full position : 0.8 ± 0.2 N(0.08 ± 0.02 kgf, 0.579 ± 0.014 lb-ft) Working temperature-40℃ ~ 80℃ (-40℉ ~ 176℉) - Description – Ignition lock switch is mounted on the clutch pedal.
Categories
- Manuals Home
- Hyundai Accent Owners Manual
- Hyundai Accent Service Manual
- New on site
- Most important about car
Copyright © 2025 hc.hamanual.com