Hyundai Accent (HC): Body (Interior and Exterior) / Fuel Filler Door

Hyundai Accent (HC) (2017 - 2022) Service Manual / Body (Interior and Exterior) / Fuel Filler Door

Contents:

Components and Components Location

- Component Location

1. Fuel filler door


Repair procedures

- Replacement

   

• Put on gloves to prevent hand injuries.

   

• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

1.Open the fuel filler door (A).

2.Loosen the mounting bolts and remove the fuel filler door (A).

Tightening torque : 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

3.To install, reverse the removal procedure.

   

• Make sure the fuel filler door locks / unlocks and opens / closes properly.

Trunk Lid

Front Door

Other information:

Hyundai Accent (HC) (2017 - 2022) Service Manual: Engine Control Module (ECM)

- ECM Terminal and Input/Output signal [M/T] ECM Terminal Function (M/T) Connector [A] Pin NoDescription 1- 2- 3Injector (Cylinder #1-1) [Low] control output 4Injector (Cylinder #1-2) [Low] control output 5- 6- 7- 8- 9- 10- 11Electric EGR Control Valve gorund 12Engine Coolant Temperature Sensor (ECTS) #2 ground 13Ignition Coil (Cylinder #1) control output 14- 15Ignition Coil (Cylinder #4) control output 16Thermal Management Module (TMM) Motor ground 17- 18Engine Cool

Hyundai Accent (HC) (2017 - 2022) Service Manual: Rear Disc Brake

- Components 1. Return spring2. Operating lever3. Stopper4. Guide rod pin5. Guide rod boot6. Caliper carrier7. Pad retainer8. Brake pad9. Pad return spring10.Caliper body - Removal 1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported. 2.Remove the rear wheel and tire (A) from front hub.Tightening torque :107.

Contents

Categories

 
Copyright © 2026
0.0108