Item | Specification |
Heater Resistance (Ω) | Approx. 2.5 [20°C (68°F)] |
Item | Specification |
Heater Resistance (Ω) | Approx. 3.0 [20°C (68°F)] |
1.Turn the ignition switch OFF.
2.Disconnect the HO2S connector.
3.Measure resistance between HO2S heater terminals 3 and 4.
4.Check that the resistance is within the specification.
Item | Specification |
Heater Resistance (Ω) | Approx. 2.5 [20°C (68°F)] |
Item | Specification |
Heater Resistance (Ω) | Approx. 3.0 [20°C (68°F)] |
1.Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.Disconnect the heated oxygen sensor connector (A).
3.Remove the heated oxygen sensor (B) using the special tool (A) [SST No. : 09392-1Y100] as shown below.
• Note that the SST (Part No. : 09392-2H100 or 09392-1Y100) is useful when removing the heated oxygen sensor.
Heated oxygen sensor installation :40.0 ~ 60.0 N.m (4.1 ~ 6.1 kgf.m, 29.5 ~ 44.3 lb-ft)
1.Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.Disconnect the heated oxygen sensor connector (A).
3.Lift the vehicle.
4.Remove the heated oxygen sensor (B) using the special tool (A) [SST No. : 09392-1Y100] as shown below.
• Note that the SST (Part No. : 09392-2H100 or 09392-1Y100) is useful when removing the heated oxygen sensor.
Heated oxygen sensor installation :40.0 ~ 60.0 N.m (4.1 ~ 6.1 kgf.m, 29.5 ~ 44.3 lb-ft)
• Install the component with the specified torques.
• Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
• DON’T use a cleaner, spray, or grease to sensing element and connector of the sensor because oil component in them may malfunction the sensor performance.
• Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).
1.Install in the reverse order of removal.
Hyundai Accent (HC) (2017 - 2022) Service Manual: Driven Pulley Pressure Sensor
- Specifications ItemSpecification Pressure (Mpa)0 - 6 Temp [(˚C)˚F](-40 to 140) -40 to 284 Output voltage (V)5 - Component Location 1. Driven pulley pressure sensor - Description Driven pulley pressure sensor measures the pressure applied to the driven pulley and transmits it to TCM. - Removal • Maintain clean condition so that foreign substance does not get into the Intelligent Variable Transmission (IVT).Hyundai Accent (HC) (2017 - 2022) Service Manual: Electric EGR Control Valve
- Description The Electric EGR Control Valve is installed in between the EGR cooler and the exhaust line and is a solenoid valve. This valve controls EGR (Exhaust Gas Recirculation) amount by the ECM's duty control signal depending on engine load and the need of intake air.The Exhaust Gas Recirculation (EGR) system is used to add the exhaust gas to intake air in order to reduce an excess of air and the temperature in the combustion chamber.