Hyundai Accent: IVT Control System / Position Switch

- Specifications

1. Position switch
2. Manual control lever

• Inspect the connector thoroughly for looseness, poor connection, bending, corrosion, contamination, deformation, or damage.

1.Disconnect the parking switch connector.

2.Turn Ignition "ON", & engine "OFF".

3.Measure the output signal in each range (P, R, N, D).Signal code table

1.Shift the gear to "N".

2.Remove the air cleaner assembly.(Refer to Engine Mechanical System - "Air Cleaner")

3.Disconnect the position switch connector (A) and loosen the shift cable mounting nut (B).

4.Remove the manual control lever (A) and the washer after removing a nut.

5.Remove the position switch (A) after removing the bolts.

1.Check that the gear is shifted to "N".

2.Lightly tighten the bolts after installing the position switch (A).

3.Lightly tighten the nut after installing the manual control lever (A).

4.Align the hole in the manual control lever with the "N" position hole of the position switch and then insert the SST position switch guide pin (09480 - A3800).

5.Tighten the manual control lever nut (A) with specified toque.

Tightening torque :17.7 - 24.5 N.m (1.8 - 2.5 kgf.m, 13.0 - 18.1 lb-ft)

6.Tighten the position switch bolts (A) with specified toque.

Tightening torque :9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

7.Push nut (A) lightly to "F" direction shown to eliminate free play of shift cable.

8.Tighten the nut (A) with the specified torque.

Tightening torque :9.8 - 14.7 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft)

9.Remove the SST (09480-A3800) from the adjusment hole.

10.Connect the position switch connector (A).

11.Install the air cleaner assembly.(Refer to Engine Mechanical System - "Air cleaner")