Hyundai Accent: Power Windows / Power Window Switch

- Circuit Diagram Power Window Main Swtich

Front+Rear, Door Lock + Drive Safety

Front+Rear, Door Lock, Auto Down

Front Only, Door Lock, Auto Dwon

Front+Rear, Auto Down

Front Only, Auto Dwon

Assist Power Window Switch (Manual)

Rear Power Window Switch (Manual)

1.Disconnect the negative (-) battery terminal.

2.Remove the front door trim.(Refer to Body - "Front Door Trim")

3.Remove the power window switch assembly (A) by pulling out both ends of the switch holders (B).

4.Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.

1.Disconnect the negative (-) battery terminal.

2.Remove the front door trim.(Refer to Body - "Front Door Trim")(Refer to Body - "Rear Door Trim")

3.Remove the power window switch (A) after disengaging the mounting clips (B).

4.Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.

1.In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool).The diagnostic system (Diagnostic tool) provides the following information.

(1)Fault Code Searching : Checking failure and code number (DTC)

(2)Data Analysis : Checking the system input/output data state

(3)Actuation test : Checking the system operation condition

(4)S/W Management : Controlling other features including system option setting and zero point adjustment

2.If diagnose the vehicle by Diagnostic tool, select "DTC Analysis" and "Vehicle".

3.Select the 'Data Analysis' and 'Car model'.

4.Select the 'DDM' to search the current state of the input/output data.

5.To forcibly actuate the input value of the module to be checked, select option 'Actuation Test'.