Hyundai Accent: Interior Trim / Rear Pillar Trim
1. Rear pillar trim
• Put on gloves to prevent hand injuries.
• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
• Take care not to bend or scratch the trim and panels.
1.Slighty remove the rear door body side weatherstrip.
2.Using a screwdriver or remover, remove the rear pillar trim (A).
3.To install, reverse the removal procedure.
• Replace any damaged clips (or pin - type retainers).
• Be sure to replace the existing clip (B) with new ones when removing or replacing the rear pillar trim.
Other information:
Hyundai Accent (HC) (2017 - 2022) Service Manual: Control Shaft Complete
- Components 1. Control shaft complete - Removal 1.Set shift lever to N position. 2.Turn OFF ignition switch and disconnect the negative (-) battery cable. 3.Remove the air cleaner assembly and air duct.(Refer to Engine Mechanical System - "Air Cleaner") 4.Remove the battery and battery tray.(Refer to Engine Electrical System - "Battery") 5.Hyundai Accent (HC) (2017 - 2022) Service Manual: Control Cable
- Components 1. Shift lever knob & boots2. Shift lever assembly3. Select cable4. Shift cable5. Retainer6. 4th fixing pin - Removal 1.Move the shift lever to 4th gear. 2.Turn OFF ignition switch and disconnect the negative (-) battery cable. 3.Remove the air cleaner assembly and air duct.(Refer to Engine Mechanical System - "Air Cleaner") 4.
Categories
- Manuals Home
- Hyundai Accent Owners Manual
- Hyundai Accent Service Manual
- New on site
- Most important about car
