Hyundai Accent: Engine Control System / Variable Intake Solenoid (VIS) Valve

Hyundai Accent (HC) (2017 - 2022) Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve

- Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens or closes this valve according to engine condition (Refer to below table).

Engine conditionVIS valveOperation
Medium speedClosedIncreasing engine performance in low engine speed by reducing intake interference among cylinders
Low / High speedOpenMinimizing intake resistance by shortening intake manifold length and increasing area of air entrance

- Specification
ItemSpecification
Coil resistance (Ω)30.0 ~ 35.0 [20°C (68°F)]

- Circuit Diagram [M/T]

Harness Connector

[A/T]

Harness Connector

- Inspection

1.Turn the ignition switch OFF.

2.Disconnect the VIS valve connector.

3.Measure resistance between VIS valve terminals 1 and 2.

Specification : Refer to "Specification"

- Removal

1.Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.Disconnect the VIS valve connector (A).

3.Disconnect the vacuum hoses (B) from the valve.

4.Remove the installation bolts, and then remove the VIS valve (A) from the surge tank.

Variable intake solenoid valve installtion bolt :9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

- Installation

   

• Install the component with the specified torques.

• Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

   

• Be careful of foreign material not to flow into the valve.

1.Install in the reverse order of removal.

Variable Force Solenoid (VFS)

Electric EGR Control Valve

Other information:

Hyundai Accent (HC) (2017 - 2022) Service Manual: FCA Radar

- Schematic Diagram - Terminal Function NoTerminal function 1- 2C-CAN LOW 3C-CAN HIGH 4GND 5IGN1 6- 7- 8- - Inspection FCA function ON / OFF switch was included to USM (User Setting Menu) and the state of the factory is ON.When the IGN ON, maintain ON condition by default. And does not reflect the driver settings when next IGN ON.

Hyundai Accent (HC) (2017 - 2022) Service Manual: Brake Oil

- Specifications Brake oil : DOT 3 or DOT 4 Reservoir capacity (cc) MAX LEVELA + B + C + D + E409 ± 20 ON LEVEL (MIN LEVEL)(H = 23 ± 1.5 mm)B + C + D138 ± 10 PARTIAL LEVELC (PRI)28 D (SEC)31 CLUTCH LEVELE12 - Replacement 1.Disconnect the battery (-) terminal. 2.Remove the brake fluid level sensor connector. 3.Remove the reservoir cap and remove the brake fluid from the reservoir tank using the cleaner.

Categories

 
Copyright © 2025 hc.hamanual.com