Hyundai Accent (HC): Body (Interior and Exterior) / Cowl Top Cover

Contents:

Components and Components Location

- Component Location

1. Cowl top cover


Repair procedures

- Replacement

1.Detach the plug hole (A), loosen the nuts, and then remove the wiper arm (B).

Tightening torque :22.6 - 26.5 N.m (2.3 - 2.7 kgf.m, 16.6 - 19.5 lb-ft)

2.Disconnect the washer nozzle (A).

3.Detach the clips, then remove the cowl top cover (B).

4.To install, reverse the removal procedure.

   

• Replace any damaged clips (or pin - type retainers).

Other information:

Hyundai Accent (HC) (2017 - 2022) Service Manual: General Service Information

- General Service Information Protection of the VehicleAlways be sure to cover fenders, seats, and floor areas prior to beginning work.     • The support rod must be inserted into the hole near the edge of the hood whenever you inspect the engine compartment to prevent the hood from falling and causing possible injury. • Make sure that the support rod has been released prior to closing the hood.

Hyundai Accent (HC) (2017 - 2022) Service Manual: Windshield defrosting and defogging

WARNING Windshield heating Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility could cause an accident resulting in serious injury or death. In this case, set the mode selection knob or button to the position and fan speed control knob or button to a lower speed.

Contents

Categories

 
Copyright © 2026
0.0064