Contents:
1. Fender assembly
• When removing the fender, wrap protective tape around a screwdriver or remover not to damage components
• Put on gloves to prevent hand injuries
• When removing the clips, use a clip remover.
1.Remove the front bumper.(Refer to Front Bumper - "Front Bumper Assembly")
2.Remove the head lamps.(Refer to Body Electrical System - "Head Lamps")
3.Loosen the front wheel guard mounting screws and pin - type retainers.
4.Using a screwdriver or remover, remove the delta garnish (A).
5.Remove the front bumper side mounthing bracket (A) after loosening the screws.
6.After loosening the mounting bolts, remove the fender assembly (A).
7.To install, reverse the removal procedure.
• Make sure the connector is plugged in properly.
• Replace any damaged clips (or pin - type retainers).
Hyundai Accent (HC) (2017 - 2022) Service Manual: Sub Frame
- Removal 1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported. 2.Remove the front wheel and tire (A) from the front hub.Tightening torque :107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft) • Be careful not to damage the hub bolts when removing the front wheel and tire. 3.Hyundai Accent (HC) (2017 - 2022) Service Manual: Piston and Connecting Rod
- Disassembly • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. • Mark all wiring connector and hoses to avoid misconnection. • To release the fuel system pressure before removing the engine assembly, start the engine without fuel pump relay.