Hyundai Accent (HC): Body (Interior and Exterior) / Front Bumper

Contents:

• Components and Components Location
• Front Bumper Assembly
• Radiator Grill

Components and Components Location

- Components

1. Front bumper assembly
2. Front bumper side bracket [LH]
3. Front bumper side bracket [RH]

Front Bumper Assembly

- Component Location

1. Front bumper assembly

• Put on gloves to prevent hand injuries.

• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

• Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

• Take care not to bend or scratch the trim and panels.

1.Loosen the bolts and clips of the front bumper upper.

2.Loosen the front bumper lower mounting clips.

3.After loosening the pin - type retainers and screws on the side of front bumper (A), detach the side part of front bumper.

• When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

4.Disconnect the front bumper connector (A).

5.Remove the front bumper assembly (A).

6.To install, reverse the removal procedure.

• Make sure the connector is plugged in properly.

• Replace any damaged clips (or pin - type retainers).

Radiator Grill

- Component Location

1. Radiator grill

• Put on gloves to prevent hand injuries.

• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

• Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

• Take care not to bend or scratch the trim and panels.

1.Remove the front bumper assembly.(Refer to Front Bumper - "Front Bumper Assembly")

2.Remove the front bumper energy absorber (A).

3.Using a screwdriver or remover, remove the radiator grill cover (A).

4.Loosen the radiator grill mounting screws.

5.Using a screwdriver or remover, pull the clip upward and remove the radiator grill (A).

6.To install, reverse the removal procedure.

• Replace any damaged clips (or pin - type retainers).