Hyundai Accent (HC): Body Electrical System / Horn

Hyundai Accent (HC) (2017 - 2022) Service Manual / Body Electrical System / Horn

Contents:

Components and Components Location

- Component Location

1. Horn switch
2. Horn relay
3. Horn
4. Clock spring


Repair procedures

- Removal

1.Remove the front bumper cover.(Refer to Body - "Front Bumper Cover")

2.Remove the horn (A) after loosening the mounting bolt and disconnecting the connector.

- Installation

1.Install the horns after connecting the horn connectors.

2.Install the front bumper cover.

- Inspection Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal.The horn should make a sound. If the horn fails to make a sound, replace it.

Horn Relay Inspection

1.Disconnect the negative (-) battery terminal.

2.Pull out the relay from the engine compartment relay block.

3.Check for continuity between the terminals.

1)After supplying power to between No. 85 and 86 power relay terminals, check that there is continuity between No. 30 and 87 terminals.

2)After disconnecting power between No. 85 and 86 power relay terminals, check that there is no continuity between No. 30 and 87 terminals.

General Information

Multifunction Switch

Other information:

Hyundai Accent (HC) (2017 - 2022) Service Manual: General Information

- General Troubleshooting Information Before Troubleshooting 1.Check applicable fuses in the appropriate fuse/relay box. 2.Using the battery checker (MCR-570 KIT), check the battery for damage, state of charge, and clean and tight connections.(Refer to Engine Electrical System - "Battery")     • Do not quick-charge a battery unless the battery ground cable has been disconnected, otherwise you will damage the alternator diodes.

Hyundai Accent (HC) (2017 - 2022) Service Manual: Specifications

- Specifications DescriptionSpecificationsLimit General TypeIn-line, DOHC 　 Number of cylinders4 　 Bore75.60 mm (2.9764 in) 　 Stroke89.0 mm (3.5039 in.)　 Total displacement1,598 cc (97.52 cu.in)　 Compression ratio11.2 ± 0.2 : 1　 Firing order1-3-4-2 　 Valve timing Intake valveOpensBTDC 42° - ATDC 38° 　 ClosesABDC 7° - ABDC 87° 　 Exhaust valveOpensBBDC 43° - ABDC 2° 　 ClosesATDC 0° - ATDC 45° 　 Cylinder head Flatness of gasket surfaceLess than 0.

Contents

Categories

 
Copyright © 2025
0.0078