Hyundai Accent (HC): Windshield Wiper/Washer / Windshield Wiper-Washer Switch

- Removal

1.Disconnect the negative (-) battery terminal.

2.Remove the steering wheel.(Refer to Steering System - "Steering Wheel")

3.Remove the steering column upper and lower shrouds after loosening the screws.(Refer to Body - "Steering Column Shroud Panal")

4.Remove the clock spring.(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")

5.Remove the multifunction switch assembly (A) after loosening the screws and disconnecting the connector (B).

- Installation

1.Install the multifunction switch.

2.Install the clock spring.

3.Install the steering column upper and lower shrouds.

4.Install the steering wheel.

- Inspection Multifunction Switch Inspection

1.Check for continuity between the terminals in each switch position according to the table.

SwitchSwitch positionSwitch terminalResistance (Ω, ±3.5%)
Front wiper switchMIST1-11330
OFF
Intermittent (AUTO)800
LOW1800
HIGH5700
Wiper intermittent volumeVolume 17-11330
Volume 2690
Volume 31310
Volume 42610
Volume 57310
Rear wiper switchOFF11-16
LOW910
HIGH2910

Inspection (With Diagnostic tool)

1.In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool).The diagnostic system (Diagnostic tool) provides the following information.

(1)Fault Code Searching : Checking failure and code number (DTC)

(2)Data Analysis : Checking the system input/output data state

(3)Actuation test : Checking the system operation condition

(4)S/W Management : Controlling other features including system option setting and zero point adjustment

2.If diagnose the vehicle by Diagnostic tool, select "DTC Analysis" and "Vehicle".

3.If check current status, select the "Data Analysis" .

4.Select the 'IBU_BCM' to search the current state of the input/output data.

Other information:

Hyundai Accent (HC) (2017 - 2022) Service Manual: General Safety Information and Caution

- Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally deploy and cause damage or injuries. • Except when performing electrical inspections, always turn the ignition switch OFF and disconnect the negative cable from the battery, and wait at least three minutes before beginning work.

Hyundai Accent (HC) (2017 - 2022) Service Manual: MDPS Assembly

- Removal 1.Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2.Put a flat tool (Ø4mm) into a guide hole located in the bottom of steering wheel and press a spring.     • When put a tool into a hole, make sure not to damage an airbag cusion by a tool. 3.Turn a steering wheel anti-clockwise, so make a guide hole (A) shown on the rightside.

Categories


 
Copyright © 2025
0.0061