Hyundai Accent: Body (Interior and Exterior) / Rear Bumper
Components and Components Location
1. Rear bumper assembly
2. Rear bumper side bracket [LH]
3. Rear bumper side bracket [RH]
4. Rear bumper under cover assembly
1. Rear bumper assembly
2. Rear bumper side bracket [LH]
3. Rear bumper side bracket [RH]
4. Rear bumper under cover assembly
Rear Bumper Assembly
1. Rear bumper assembly
• Put on gloves to prevent hand injuries.
• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
• Take care not to bend or scratch the trim and panels.
1.Remove the combination lamp cover (A).
2.Disconnect the mounting nuts and rear combination lamp connector (A).
3.Remove the rear combination lamp (A).
4.After loosening the pin - type retainers and screws on the side of rear bumper (A), detach the side part of rear bumper.
• Be careful not to damage the tabs on the side part of front bumper.
5.Remove the rear bumper side under cover (A) after loosening the mounting nuts and clips.
6.Loosen the mounting bolts.
7.Remove the rear bumper assembly (A).
8.Disconnect the rear bumper connector (A).
9.To install, reverse the removal procedure.
• Make sure the connector is plugged in properly.
• Replace any damaged clips (or pin - type retainers).
Rear Bumper beam Assembly
1. Rear bumper beam assembly
• Put on gloves to prevent hand injuries.
• When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
• Take care not to bend or scratch the trim and panels.
1.Remove the rear bumper assembly.(Refer to Rear Bumper - "Rear Bumper Assembly")
2.Disconnect the rear bumper beam mounting wiring harness (A).
3.After loosening the mounting clips, remove the rear bumper beam assembly (A).
4.To install, reverse the removal procedure.
• Make sure the connector is plugged in properly.
• Replace any damaged clips (or pin - type retainers).
Other information:
Hyundai Accent (HC) (2017 - 2022) Service Manual: Repair procedures
- Inspection Front Door Lock Module Inspection 1.Remove the front door trim.(Refer to Body - "Front Door Trim") 2.Remove the front door module.(Refer to Body - "Front Door Module") 3.Disconnect the connectors from the actuator. NoPin Information LHRH 1Motor 1Lock / UnLock switch 2Motor 2COM 3-Key Lock switch 4Key Unlock switchKey Unlock switch 5Key Lock switch- 6COMMotor 2 7Lock / UnLock switchMotor 1 4.Hyundai Accent (HC) (2017 - 2022) Service Manual: Integrated Thermal Management Module (ITM)
- Components [Intelligent Variable Transmission (IVT) System] 1. Integrated thermal management module (ITM)2 . Integrated thermal management module (ITM) O-ring3. Heater pipe B4. Heater water hose5. Heater pipe A6 . Heater pipe A gasket7 . Water inlet fitting8 . Water inlet fitting gasket [Manual Transaxle System] 1. Integrated thermal management module (ITM)2 .
Contents
Categories
- Manuals Home
- Hyundai Accent Owners Manual
- Hyundai Accent Service Manual
- New on site
- Most important about car
