Hyundai Accent (HC): Body (Interior and Exterior) / Front Seat Belt

Contents:

• Components and Components Location
• Front Seat Belt Pretensioner
• Height Adjust
• Front Seat Belt Buckle

Components and Components Location

- Components

1. Front seat belt pretensioner
2. Height adjuster
3. Front seat belt buckle

Front Seat Belt Pretensioner

- Component Location

1. Front seat belt pretensioner

• When installing the belt, make sure not to damage the pretensioner.

1.Remove the center pillar upper trim.(Refer to Interior Trim - "Center Pillar Trim")

2.After loosening the front belt upper anchor mounting bolt, remove the front belt upper anchor (A).

Tightening torque :39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)

3.Disconnect the connector (A)

4.Loosen the mounting bolt and removing the front safety belt retractor (B).

Tightening torque :39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)

5.To install, reverse the removal procedure.

• After installing the front seat belt retractor, check that the air bag warning indicator illuminates for about 6 seconds when the ignition is ON and then goes out.

• Make sure the connector is plugged in properly.

• Replace any damaged clips (or pin - type retainers).

Height Adjust

- Component Location

1. Height adjust

1.Remove the front seat belt upper anchor.(Refer to Front Seat Belt - "Front Seat Belt Pretensioner")

2.After loosening the mounting bolts, remove the height adjust (A).

Tightening torque :39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)

3.To install, reverse the removal procedure.

• Replace any damaged clips (or pin - type retainers).

Front Seat Belt Buckle

- Component Location

1. Front seat belt buckle

1.Remove the front seat assembly.(Refer to Front Seat - "Front Seat Assembly")

2.Disconnect the front seat belt buckle connector wiring (A).

3.After loosening the mounting bolt, remove the front seat belt buckle (A).

Tightening torque :39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)

4.To install, reverse the removal procedure.

• Make sure the connector is plugged in properly.