Hyundai Accent (HC): Steering System

Contents:

Specifications ➤

Troubleshooting

- Troubleshooting

Trouble SymptomCause of the symptomRemedy
Excessive play in steeringLoose U-joint boltRetighten or replace as necessary
Loose yoke plugRetighten
Loose steering gear mounting boltsRetighten
Loose or worn tie rod endRetighten or replace as necessary
Steering wheel does not return to its original positionExcessive turning resistance of tie rod endReplace
Yoke plug excessively tightAdjust
Tie rod and/or ball joint cannot turn smoothlyReplace
Loose mounting of gear box at the subframeRetighten
Worn steering shaft joint and/or body grommetCorrect or replace
Distorted rackReplace
Rattling or chucking noise in the rack and pinionLoose steering gear box mountingReposition
Loose tie rod end and/or ball jointRepace
Worn tie rod and/or ball jointRepace
Loose yoke plugReplace

Repair procedures

- Inspection Steering Wheel Play Inspection

1.Turn the steering wheel so that the front wheels can face straight ahead.

2.Measure the distance the steering wheel can be turned without moving the front wheels.

Standard value : 30mm (1.18in.) or less

3.If the play exceeds standard value, inspect the steering column, shaft, and linkages.

Checking stationary steering effort

1.Position the vehicle on a level surface and place the steering wheel in the straight ahead position.

2.Attach a spring scale to the steering wheel. With the engine speed 600 ±100 rpm, pull the scale and read it as soon as the tires begin to turn.

Standard value : 3.0kgf or less

3.If the measured value exceeds standard value, inspect the power steering gear box and ESP system.

Steering wheel ➤

Motor Driven Power Steering ➤

Other information:

Hyundai Accent (HC) (2017 - 2022) Service Manual: Repair procedures

- Inspection Inspection Item • Battery efficiency inspection • Battery voltage inspection • Charging voltage insptection • General inspection • Terminal tightening state inspection • Engine/ transaxle ground state inspection • Wiring harness ground state inspection • Electrical Specified Value Inspection • Vehicle parasitic current inspection • Battery capacity inspection Battery Efficiency Inspection     • Check that the battery cables are connected to the correct terminals.

Hyundai Accent (HC) (2017 - 2022) Service Manual: E-Module

- Specifications Drive Pulley Speed Sensor ItemSpecification TypeHall sensor Output voltage (V)High : 1.18 - 1.68 (Nor : 1.4) Low : 0.59 - 0.84 (Nor : 0.7) Turbine Speed Sensor ItemSpecification TypeHall sensor Output voltage (V)High : 1.18 - 1.68 (Nor : 1.4) Low : 0.59 - 0.84 (Nor : 0.7) Oil Temperature Sensor ItemSpecification Type*NTC thermistor Temp.

Contents

Categories


 
Copyright © 2025
0.0073