Hyundai Accent (HC): Manual Transaxle System (M6CF1) / Troubleshooting
Hyundai Accent (HC) (2017 - 2022) Service Manual / Manual Transaxle System (M6CF1) / Troubleshooting
| Symptom | Suspected Area | Remedy |
| Abnormal noise | Oil level (Low) | To adding oil after inspect the parts (Oil seal, Drain plug, filler plug). |
| Oil (Wrong) | Replace the oil. | |
| Synchronizer ring (Worn or damaged) | Replace the synchronizer ring. | |
| Gear (Worn or damaged) | Replace the gear. | |
| Bearing (Worn or damaged) | Replace the bearing. | |
| Oil leak | Oil level (High) | Inspect the oil level. |
| Gasket (Damaged) | Replace the gasket. | |
| Oil seal (Worn or damaged) | Replace the oil seal. | |
| Hard shifting or impossible to shift | Oil (Wrong) | Replace the oil. |
| Clutch (Dragging) | Inspect the clutch parts (Release fork & bearing, Clutch disc) | |
| Shift fork (Worn) | Replace the shift fork. | |
| Synchronizer ring (Worn or damaged) | Replace the synchronizer ring. | |
| Gear (Worn or damaged) | Replace the gear. | |
| Hub sleeve (Worn or damaged) | Replace the hub sleeve. | |
| Jumps out of gear or shift lever moves excessively | Shift fork (Worn) | Replace the shift fork. |
| Hub sleeve (Worn or damaged) | Replace the hub sleeve. | |
| Gear (Worn or damaged) | Replace the gear. | |
| Bearing (Worn or damaged) | Replace the bearing. |
Other information:
Hyundai Accent (HC) (2017 - 2022) Service Manual: Blower Unit
- Component Location 1. Blower unit assembly - Components 1. Seal2. Intake duct case3. Intake actuator4. Intake door5. Intake lower case6. Blower upper case7. Blower unit pad8. Blower lower case9. Blower motor10. Air filter11. Air filter cover12. PWM Blower module - Replacement When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.Hyundai Accent (HC) (2017 - 2022) Service Manual: Parking Brake Cable
- Removal [Rear Disc Brake Type] 1.Disconnect the negative (-) battery cable. 2.Release the parking brake. 3.Remove the floor console assembly. (Refer to Body - "Floor Console") 4.Disconnect the connector of parking brake switch. 5.Remove the parking brake switch. 6.Remove the parking brake cable after loosening the nut (A). 7.Loosen the wheel nuts slightly.
Categories
- Manuals Home
- Hyundai Accent Owners Manual
- Hyundai Accent Service Manual
- Questions & Answers
- Video Guides
- Useful Resources
- New on site
- Most important about car
- Privacy Policy
Copyright © 2025
0.0071
0.0071