Hyundai Accent (HC): Body (Interior and Exterior)

Contents:

Specifications

- Specifications

ItemsSpecification
HoodTypeFront opening type, rear hinged, stay rod type
Front DoorConstructionFront hinged, frame door construction
Regulator systemWire drum type
Locking systemPin - fork system
Rear DoorConstructionFront hinged, frame door construction
Regulator systemWire drum type
Locking systemPin - fork system
Trunk LidTypeTorsior bay type
Seat BeltsFront3 point type with Emergency Locking Retractor (E.L.R)
Rear3 point type with Emergency Locking Retractor (E.L.R)

- Tightening Torque
ItemsN.mKgf.mlb - ft
Front and rear doorsDoor hinge to body23.6 - 31.92.4 - 3.217.4 - 23.5
Door hinge to door22.6 - 27.52.3 - 2.816.2 - 19.9
Door checker to door6.9 - 10.80.7 - 1.15.1 - 8.0
Door checker to body21.6 - 32.42.2 - 3.315.9 - 23.9
Door glass mounting bolt7.8 - 11.80.8 - 1.25.8 - 8.7
Outside handle base mounting bolt6.9 - 10.80.7 - 1.15.1 - 8.0
Door channel mounting nuts3.9 - 5.90.4 - 0.62.9 - 4.3
Door latch mounting screws7.8 - 10.80.8 - 1.15.8 - 8.0
Door module mounting bolts8.8 - 13.70.9 - 1.46.5 - 10.1
Door striker mounting bolts8.8 - 13.70.9 - 1.46.5 - 10.1
Trunk lidTrunk lid mounting bolts7.8 - 11.80.8 - 1.25.8 - 8.7
Trunk lid latch mounting bolts7.8 - 11.80.8 - 1.25.8 - 8.7
HoodHood hinge mounting bolts21.6 - 26.52.2 - 2.715.9 - 19.5
Hood latch to body6.9 - 10.80.7 - 1.15.1 - 8.0
Seat  Front seat mounting bolts49.0 - 63.75.0 - 6.536.2 - 47.0
Front seat frame mounting bolts44.1 - 53.94.5 - 5.532.5 - 39.8
Front seat cushion track mounting bolts44.1 - 53.94.5 - 5.532.5 - 39.8
Rear seat mounting bolts16.7 - 25.51.7 - 2.612.3 - 18.8
Rear seat latch mounting bolts19.6 - 29.42.0 - 3.014.5 - 21.7
Rear seat frame mounting bolts44.1 - 53.94.5 - 5.532.5 - 39.8
Seat beltHeight adjuster mounting bolts39.2 - 53.94.0 - 5.528.9 - 39.8
Front seat belt upper anchor mounting bolt39.2 - 53.94.0 - 5.528.9 - 39.8
Front seat belt pretensioner mounting bolt39.2 - 53.94.0 - 5.528.9 - 39.8
Rear seat belt lower anchor mounting bolts39.2 - 53.94.0 - 5.528.9 - 39.8
Rear seat belt retractor mounting bolt39.2 - 53.94.0 - 5.528.9 - 39.8
Rear center seat belt retractor mounting bolt39.2 - 53.94.0 - 5.528.9 - 39.8
Seat belt buckle mounting bolt39.2 - 53.94.0 - 5.528.9 - 39.8
Outside rearview mirrorOutside rearview mirror mounting bolts6.9 - 10.80.7 - 1.15.1 - 8.0
FenderFender panel mounting bolts7.8 - 11.80.8 - 1.25.8 - 8.7
Wiper armWiper arm mounting nuts22.6 - 26.52.3 - 2.716.6 - 19.5
SunroofSunroof mounting nuts 3.9 - 5.90.4 - 0.62.9 - 4.3
Sunroof mounting bolts7.8 - 11.80.8 - 1.25.8 - 8.7

Special Service Tools

- Special Service Tools

Tool (Number and name)IllustrationUse
09880 - 4F000
Hog ring clip installer

Hog ring clip installation

Troubleshooting

- Troubleshooting

SymptomPassible CauseRemedy (Refer to page)
Water leaks from panorama sunroofDeteriorated roof lid weatherstripReplace
Excessive roof lid - to - body clearance and improperly fitted weatherstripAdjust
Wind noise around sunroof Loose or deformed deflector, gaps in body workRetighten adjust or replace
Noise created by moving sunroof lidForeign particles lodged in guide railCheck drive cable and guide rails for foreign particles
Loose guide rails and lidRetighten
Motor runs but sunroof does not move or moves only partiallyForeign particles lodged in guide railAdjust or replace
Incorrect engagement of motor pinion with drive cable
Decrease in motor's clutch slipping force
Increased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc. due tomal adjustment of sunroof
Noise in motor (clutch slipping noise from motor when sunroof is fully opened or closed) is considered as normalIncorrect engagement of motor pinion with drive cableCheck pinion installation and
Re - tighten motor
Worn out or damaged motor pinion bearingReplace motor assembly
Worn out or deformed drive cableReplace
Door glass fails to operate up and downIncorrect window glass installationAdjust position
Damaged or faulty regulator arm or regulatorCorrect or replace
Door does not open or close completelyIncorrect door installationAdjust position
Defective door check assemblyCorrect or replace
Door hinge requires greaseApply grease
Hood does not open or close completelyStriker and latch not properly alignedAdjust
Incorrectly installed hoodAdjust
Incorrect hood bumper heightAdjust
Water leaks through windshield and rear windowDefective sealFill with sealant
Defective flangeCorrect

Fender ➤

Hood ➤

Liftgate ➤

Trunk Lid ➤

Fuel Filler Door ➤

Front Door ➤

Rear Door ➤

Body Side Molding ➤

Sunroof ➤

Mirror ➤

Cowl Top Cover ➤

Floor Console ➤

Crash Pad ➤

Roof Trim ➤

Interior Trim ➤

Trunk Trim ➤

Windshield Glass ➤

Rear Window Glass ➤

Floor Carpet ➤

Front Bumper ➤

Rear Bumper ➤

Front Seat ➤

Rear Seat ➤

Front Seat Belt ➤

Rear Seat Belt ➤

Other information:

Hyundai Accent (HC) (2017 - 2022) Service Manual: Description and Operation

- Function NoItemDescription 1Washer Linked Wiper – If the washer switch is pressed ON for 0.06 second with the vehicle mode in IGN2, the wiper relay is turned ON after washer switch ON, and then the wiper relay is turned OFF after wiper parking signal ON. 2MIST Linked Wiper – If the wiper mist switch is pressed ON for 0.6 second with the vehicle mode in IGN2, the wiper relay is turned ON, and then OFF after wiper parking signal ON.

Hyundai Accent (HC) (2017 - 2022) Service Manual: Engine Control Module (ECM)

- ECM Terminal and Input/Output signal [M/T] ECM Terminal Function (M/T) Connector [A] Pin NoDescription 1- 2- 3Injector (Cylinder #1-1) [Low] control output 4Injector (Cylinder #1-2) [Low] control output 5- 6- 7- 8- 9- 10- 11Electric EGR Control Valve gorund 12Engine Coolant Temperature Sensor (ECTS) #2 ground 13Ignition Coil (Cylinder #1) control output 14- 15Ignition Coil (Cylinder #4) control output 16Thermal Management Module (TMM) Motor ground 17- 18Engine Cool

Contents

Categories

 
Copyright © 2025
0.0085